Fire pumps are an essential part of many water-based fire protection systems. Fire Pumps are used to increase the water pressure (measured in psi) when the original water source is not adequate for the system it’s supplying. These are commonly found in buildings that tend to have a high-pressure demand such as high-rises or storage warehouses.
There are many types of fire pumps available and can be driven by electric motor or diesel engine. It is important to select the correct type of pump for the installation project to avoid excessive costs, and to avoid excessive pressures that might cause your system damage. If all the factors are not taken into consideration it could result in a pump installation that does not achieve the necessary pressure requirements which could require a new pump to be installed.
Deluge systems are generally used in high-hazard areas such as power plants, aircraft hangars, and chemical plants.
Dry pendent sprinklers are typically installed in food process plants and box-in-box freezers where temperatures are below 40 degrees F.
Dry pipe sprinkler systems are generally used in cold climates and are highly effective in cold-temperature fire protection.
Early Suppression Fast Response (ESFR) systems are quick-responding, high-volume sprinkler systems that provide exceptional protection for high-piled storage occupancies.
Fire pumps are an essential part of many water-based fire protection systems. Fire Pumps are used to increase the water pressure (measured in psi) when the original water source is not adequate for the system it’s supplying.
Pre-action fire sprinkler systems employ the basic concept of a dry pipe system in that water is not normally contained within the pipes.
Wet pipe systems are the most common fire sprinkler systems. A wet pipe system is one in which water is constantly maintained within the sprinkler piping.
A special hazards fire suppression system is used to put out fires in areas where water damage from fire sprinklers can cause costly or irreparable damage to the assets being protected.
Linear Heat Detection (LHD) is an important component of fire protection systems, as it is designed to detect heat along the length of a sensor cable.
